To Next PageTo Next PageWhy is my Grizzly G0640X Saw vibrating when cutting?
If your Grizzly Saw is vibrating when cutting, it could be due to a loose or damaged blade. Try tightening or replacing the blade. Another possible cause is sawdust buildup on the wheels. Make sure to clean all sawdust from the rubber tires on the wheels.
How to improve cut quality on my Grizzly G0640X?
If you're experiencing rough or poor quality cuts with your Grizzly Saw, it might be because you are feeding the workpiece too fast. Try reducing the feed rate. Also, check if the blade guides are adjusted incorrectly and readjust all blade guides and support bearings, if needed.
Why does my Grizzly G0640X Saw leave burn marks?
If you notice burn marks on the edge of the cut when using your Grizzly Saw, it might be because there is too much side pressure when feeding the workpiece, causing the blade to bind. Try feeding the workpiece straight into the blade. Also, the blade could be too wide for the size of radius being cut. Consider installing a smaller width blade or increasing blade tension.
Why does my Grizzly Saw slow down when cutting?
If your Grizzly Saw machine slows down during operation, it could be because you are feeding the workpiece too fast. Try reducing the feed rate. Another possibility is that the blade is dull, in which case you should replace the blade.
How to prevent sawdust buildup in my Grizzly Saw?
If you're experiencing sawdust buildup inside the cabinet of your Grizzly Saw, it could be due to a clogged dust port. Try cleaning out the dust port. Another possible cause is low CFM (airflow) from the shop vacuum. Check dust hoses for leaks or clogs, or connect the saw to a more powerful shop vacuum.
Why is my Grizzly Saw making a ticking sound?
If your Grizzly Saw is making a ticking sound when running, it could be because the blade weld is contacting guide/support bearings. Use a file or stone to smooth and round the back of the blade and slightly loosen the blade guides. The blade weld may also be failing, so inspect and replace the blade if necessary.
How to fix non-square cuts on my Grizzly G0640X Saw?
If your Grizzly Saw cuts are not square (vertically), it could be because the table tilt is not adjusted to 0° or the positive stop has moved out of adjustment. Adjust the table tilt to 0° and readjust the positive stop if necessary. Another possible cause is that the table tilt scale pointer is not calibrated. Calibrate the table tilt scale pointer to 0°. It's also possible that the table is not square to the blade, so try shimming the table.
What to do if the blade contacts the table insert on my Grizzly Saw?
If the blade is contacting the table insert on your Grizzly Saw, it could be because the insert is installed upside down or backwards. Re-install the insert a different way. Another possible cause is that the table is improperly mounted or aligned, so align the table.
General| Blade Diameter | 10 inches |
|---|---|
| Table Size | 27 inches x 40 inches |
| Max Cutting Depth at 90° | 3-1/8 inches |
| Max Cutting Height at 45° | 2-1/4 inches |
| Dust Port Size | 4 inches |
