To Next PageTo Next PageWhat to do if my Grizzly Planer motor stalls and blows fuses?
If your Grizzly Planer motor stalls, resulting in blown fuses or a tripped circuit, here's what to check: * Inspect the motor connections for loose or shorted terminals or worn insulation. * Correct any low voltage conditions. * Ensure you're using the correct fuses or circuit breakers. * Reduce the load on the motor.
Why does my Grizzly Planer motor overheat?
Your Grizzly Planer motor may be overheating because it's overloaded or because air circulation through the motor is restricted. Try reducing the load on the motor and cleaning it to allow for normal air circulation.
What to do if my Grizzly G1021 machine is loud when cutting, overheats, or bogs down?
If your Grizzly Planer is loud while cutting and either overheats or bogs down, it could be due to an excessive depth of cut or dull knives. Try decreasing the depth of cut and sharpening the knives.
What to do if my Grizzly Planer motor won't start?
If the motor on your Grizzly Planer won't start, check the power line for the correct voltage. Also, inspect all lead connections on the motor for loose or open connections.
What to do if my Grizzly Planer motor won't start and the fuses blow?
If your Grizzly Planer motor won't start and the fuses or circuit breakers blow, inspect the line cord or plug for damaged insulation and shorted wires. Also, inspect all connections on the motor for loose or shorted terminals or worn insulation. Finally, ensure that you have installed the correct fuses or circuit breakers.
Why is my Grizzly G1021 Planer machine slowing down when operating?
If your Grizzly Planer machine slows down during operation, it may be due to a feed rate that's too high or a depth of cut that's too great. Try feeding the workpiece slower and reducing the depth of cut.
Why is my Grizzly G1021 making a loud, repetitious noise?
A loud, repetitious noise coming from your Grizzly Planer could be caused by several things. Inspect the keys and setscrews on the pulleys, replacing or tightening them if necessary. Also, check if the motor fan is hitting the cover and tighten the fan or shim the cover. Lastly, inspect the V-belt for defects and replace it if needed.
Why does my Grizzly G1021 Planer table move down while cutting?
If the table on your Grizzly Planer moves down while cutting, the knives may be dull. Try replacing them.
General| Model | G1021 |
|---|---|
| Type | Planer |
| Number of Knives | 3 |
| Maximum Cutting Width | 15 inches |
| Maximum Cutting Depth | 1/8 inch |
| Dust Port Size | 4 inches |
| Feed Rate | 20 FPM |
| Feed Speed | 20 FPM |
