-6- G1023 Heavy-Duty Table Saw
Clean up
The table and other unpainted parts of the Model
G1023 are coated with a waxy oil that protects
them from corrosion during shipment. Remove
the protective coating with mineral spirits and
paper towels. Do not use gasoline or other petro-
leum based solvents because of their extremely
low flash points. Do not use chlorine-based sol-
vents – if you happen to splash some onto a
painted surface, you’ll ruin the finish.
WARNING!
Follow the safety rules listed below when
working with solvents:
1. Read and follow all directions and warnings
on the solvent label.
2. Work only in a well ventilated area.
3. Do not work near any type of open flame
(e.g., pilot lights, kerosene heaters, and so
on).
4. DO NOT smoke while working with flamma-
ble material.
5. Paper towels from the cleaning process are
extremely combustible. Dispose of waste
towels so they do not create a fire hazard.
Site Considerations
1. Floor Load: Your Model G1023 Table Saw
represents a large weight load in a small
footprint. Most commercial floors are suitable
for the Model G1023. Some residential floors
may require additional bracing to support
both machine and operator.
2. Working Clearances: Consider existing and
anticipated needs, size of material to be
processed through each machine, and
space for auxiliary stands, work tables or
other machinery when establishing a loca-
tion for your Table Saw.
3. Lighting and Outlets: Lighting should be
bright enough to eliminate shadow and pre-
vent eye strain. Electrical circuits should be
dedicated or large enough to handle amper-
age requirements. Outlets should be located
near each machine so power or extension
cords are clear of high-traffic areas. Observe
local electrical codes for proper installation
of new lighting, outlets, or circuits.
To Next Page
