OM/SM-DEE (CE)
17
Charged at the factory with treated, distilled water, the
steam source provides kettle temperature of 65/ C to
150/ C. Controls for the unit include a thermostat,
pressure gauge, gauge glass, safety valve, pressure
limit control, low water cut-off and an on/off switch.
Service connections are required for 230 Volt, single
phase, 50 Hz and 400 Volt, three phase, 50 Hz
electricity.
IMPORTANT
Prior to operation, clean out the kettle pan
thoroughly using hot water and detergent. Rinse
out and dry thoroughly.
7.1.2 Operational and Maintenance Safety
WARNING
INSTALLATION OF THE UNIT MUST BE DONE BY
PERSONNEL QUALIFIED TO WORK WITH
ELECTRICITY AND PLUMBING IN ACCORDANCE
WITH ALL APPLICABLE CODES.
BEFORE REPLACING ANY PARTS, DISCONNECT
THE UNIT FROM THE ELECTRIC POWER
SUPPLY.
TO PREVENT SHOCKS, ALL APPLIANCES
WHETHER GAS OR ELECTRIC, MUST BE
EARTHED.
CAUTION
BE SURE ALL OPERATORS READ,
UNDERSTAND, AND FOLLOW THE OPERATING
INSTRUCTIONS, CAUTIONS AND SAFETY
INSTRUCTIONS CONTAINED IN THIS MANUAL.
To Next Page
Loading...
Need help?
General
