OM/SM-DEE (CE)
7
Each day, confirm the jacket water level by
checking the water gauge.
Section 2 - Initial Start-Up
IMPORTANT:
BE SURE ALL OPERATORS READ, UNDERSTAND AND FOLLOW THE OPERATING INSTRUCTIONS,
CAUTIONS AND SAFETY INSTRUCTIONS CONTAINED IN THIS MANUAL.
Now that the kettle has been installed, you
should test it to ensure that the unit is operating
correctly.
1. Remove all literature and packing materials
from inside and outside of the unit.
2. If the unit is equipped with a draw-off valve
(product outlet), clean out any material which
might clog or damage the draw-off.
3. Confirm that the tilting mechanism is
operating properly by tilting the kettle
through its full range. Then return the kettle
to the upright position.
4. Turn on the electrical service to the unit.
5. Pour 2-4 liters of water into the kettle.
6. Following “To Start Kettle” instructions in the
“Operation” section of this manual, begin
heating the water at the highest thermostat
setting. The heating indicator light should
come on immediately, and heating should
continue until the water boils.
WARNING
AVOID ALL DIRECT CONTACT WITH HOT
SURFACES. DIRECT SKIN CONTACT
COULD RESULT IN SEVERE BURNS.
AVOID ALL DIRECT CONTACT WITH HOT
FOOD OR WATER IN THE KETTLE. DIRECT
CONTACT COULD RESULT IN SEVERE
BURNS.
7. To shut down the unit, turn the thermostat
dial to “OFF”.
If the unit functions as described above, it is
ready for use. If the unit does not function as
described, contact your local Groen Certified
Service Agency.
To Next Page
Loading...
Need help?
General
