EasyManua.ls Logo

Groen EE-20 - User Manual

Groen EE-20
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
This manual provides information for:
MODELS
EE (CE) International
STEAM JACKETED
KETTLES
· Self-Contained
· Electric Heated
· Floor Mounted
· Stationary
OPERATOR/SERVICE MANUAL
IMPORTANT INFORMATION, KEEP FOR OPERATOR
PART NUMBER 127731, REV. E (08/09)
THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE.
READ, UNDERSTAND AND FOLLOW THE INSTRUCTIONS AND
WARNINGS CONTAINED IN THIS MANUAL.
FOR YOUR SAFETY
Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
WARNING
Improper installation, adjustment, alteration, service or
maintenance can cause property damage, injury or death.
Read the installation, operating and maintenance instructions
thoroughly before installing or servicing this equipment.
NOTIFY CARRIER OF DAMAGE AT ONCE
It is the responsibility of the consignee to inspect the container upon receipt of
same and to determine the possibility of any damage, including concealed dam-
age. Unified Brands suggests that if you are suspicious of damage to make a
notation on the delivery receipt. It will be the responsibility of the consignee to file
a claim with the carrier. We recommend that you do so at once.
Manufacture Service/Questions 888-994-7636.
Information contained in this document is known to be current and accurate at the time
of printing/creation. Unified Brands recommends referencing our product line websites,
unifiedbrands.net, for the most updated product information and specifications.
1055 Mendell Davis Drive
Jackson, MS 39272
888-994-7636, fax 888-864-7636
unifiedbrands.net

Other manuals for Groen EE-20

Questions and Answers

  • B
    Bryan NixonJul 30, 2025
    How to troubleshoot a Groen EE-20 Kettle that will not heat or turn on?
    • E
      Evelyn WigginsJul 30, 2025
      If your Groen Kettle isn't heating up or turning on, there are several things you can check: * Ensure the unit is getting electric power. * Verify the water level in the jacket. * Inspect the control circuit fuses in the control console, replacing any blown fuses with ones of the same amp rating. * Look for any loose or broken wires. * Check the operation of the variable thermostat, the low water cutout switch, and the water probe. * Confirm that the high limit pressure switch is closed.
  • T
    Trevor GonzalezAug 3, 2025
    Why does the safety valve pop on my Groen Kettle?
    • Z
      ztaylorAug 3, 2025
      If the safety valve on your Groen Kettle is popping, consider the following: * Check for air in the jacket. * Determine if the kettle was being heated while empty when the valve popped. * Inspect the pressure limit switch. * Examine the thermostat operation to ensure it clicks when the dial is rotated above and below the set temperature. * Check the safety valve itself; if it pops at pressures below 48 PSI, it should be replaced. * Verify the contactor is de-energized.
  • A
    Alicia Elliott DVMAug 7, 2025
    What to do if Groen EE-20 Kettle continues heating after reaching desired temperature?
    • A
      Andrew GrahamAug 8, 2025
      If your Groen Kettle keeps heating even after reaching the set temperature, consider these potential causes: * Check the thermostat dial setting. * Inspect the thermostat circuit for a short. * Examine the thermostat calibration and its overall operation, ensuring it clicks when the dial is rotated above and below the set temperature. * Check the contactor to see if it's energized or stuck.
  • K
    Kaitlyn ScottAug 12, 2025
    Why Groen EE-20 Kettle will not heat, but heating indicator is on?
    • B
      butlertaraAug 12, 2025
      If your Groen Kettle's heating indicator is on but the kettle isn't heating, here's what to check: * Look for air in the jacket. * Inspect the contactor. * Use an ohmmeter to check the heater elements for a ground short or open element. If the element is defective, call Groen.
  • P
    pmillerAug 16, 2025
    What to do if Groen Kettle stops heating before reaching desired temperature?
    • J
      Justin KnightAug 16, 2025
      If your Groen Kettle stops heating before reaching the desired temperature, check the following: * Verify the thermostat dial setting and calibration. * Ensure the jacket water level is adequate. * Check the thermostat operation, making sure it clicks when the dial is rotated above and below the set temperature. * Inspect the pressure limit switch.
  • L
    Leslie WilliamsAug 21, 2025
    Why does my Groen EE-20 Kettle heat slowly?
    • S
      Sheila SanchezAug 21, 2025
      If your Groen Kettle is heating slowly, you should check for the following: * Air in the jacket. * Heater elements using an ohmmeter for ground short or open element. If an element is defective, call Groen. * Voltage of main power source.
  • J
    Jessica GarciaAug 26, 2025
    How to fix a Groen EE-20 Kettle safety valve that leaks steam?
    • C
      curtismichaelAug 26, 2025
      If the safety valve on your Groen Kettle is leaking steam: * Check for contamination preventing the valve from seating properly. With full pressure in the jacket, briefly pull the chain to blow the valve clean, then let it snap back. * Inspect the safety valve for defects and replace it with an identical valve if necessary.

Summary

Critical Safety Information

General Safety Precautions

Important safety advice including preventing fire hazards from flammable liquids and general warnings.

Installation and Service Warnings

Improper installation, adjustment, alteration, or service can cause damage, injury, or death. Read instructions carefully.

Installation Requirements and Personnel Qualification

Appliances must be installed by competent persons and operated by qualified personnel, adhering to regulations.

Electrical Safety and Grounding

Ensures proper electrical installation, grounding, and awareness of high voltage within control compartments.

Operational and Maintenance Safety

Precautions for handling hot surfaces, contents, cleaning agents, and performing maintenance safely.

Installation

Operation

To Start Kettle

Instructions for starting the kettle, including indicator lights and daily checks for water level and vacuum.

Cleaning

Maintenance

Troubleshooting

Kettle Not Heating or Starting

Checks for when the kettle does not heat or turn on, and when heating indicator is on but kettle is not heating.

Kettle Overheating or Stopping Prematurely

Troubleshooting for kettles that continue heating or stop heating before reaching the desired temperature.

Kettle Heats Slowly

Checks for slow heating, including air in the jacket and heater element issues.

Safety Valve Issues

Diagnosing and resolving issues with the safety valve popping or leaking steam.

Wiring Schematics

Limited Warranty

Groen EE-20 Specifications

General IconGeneral
BrandGroen
ModelEE-20
CategoryKettle
LanguageEnglish

Related product manuals