OM/SM-EE-CE 11
11
8.1 Suggested Tools:
a. Cleaner, such as Klenzade HC-10 or
HC-32 from ECOLAB, Inc.
b. Kettle brushes in good condition (and a
bottle brush, for the draw-off).
c. Sanitizer such as Klenzade XY-12.
d. Film remover such as Klenzade LC-30.
8.2 Precautions
Before cleaning, shut off the kettle by turning
the thermostat dial to “OFF,” and shut off all
electric power to the unit at a remote switch,
such as the circuit breaker.
8.3 Procedure
a. Clean food-contact surfaces as soon as
possible after use. If the unit is in
continuous use, thoroughly clean and
sanitize the interior and exterior at least
once every 12 hours.
b. Scrape and flush out food residues. Be
careful not to scratch the kettle with
metal implements. Close the draw-off.
c. Prepare a hot solution of the detergent/
cleaning compound as instructed by the
supplier. Clean the unit thoroughly. a cloth
moistened with cleaning solution can be
used to clean controls, housing, and
electrical conduits.
Use only a sponge, cloth or plastic brush
to clean the kettle.
Scrapers or steel wool can harm
the kettle surface.
d. Rinse the kettle thoroughly with hot water,
then drain completely.
e. Disassemble the tangent draw-off valve.
Clean the draw-off port and each valve part
with a brush.
f. Rinse the kettle and draw-off valve parts
thoroughly with hot water, then drain
completely.
8.0 Cleaning
WARNING
KEEP WATER AND SOLUTIONS AWAY FROM
CONTROLS AND ELECTRICAL EQUIPMENT.
NEVER SPRAY THE SUPPORT HOUSING OR
ELECTRICAL CONNECTIONS.
CAUTION
MOST CLEANERS ARE HARMFUL TO THE
SKIN, EYES, MUCOUS MEMBRANES, AND
CLOTHING. PRECAUTIONS SHOULD BE
TAKEN. WEAR RUBBER GLOVES, GOGGLES
OR FACE SHIELD, AND PROTECTIVE
CLOTHING. READ THE WARNINGS AND
FOLLOW THE DIRECTIONS ON THE LABEL
OF THE CLEANER CAREFULLY
CAUTION
DO NOT MIX THE PARTS OF DIFFERENT
DRAW-OFF ASSEMBLIES DURING
WASHING. THE PARTS ARE NOT ALWAYS
INTERCHANGEABLE.
To Next Page
Loading...
Need help?
General
