OM-HH
6
The kettle will be banded to a skid, inside a
heavy carton.
Assemble and attach the tangent draw-off
valve after the kettle is unpacked.
Inspection & Unpacking
The unit will arrive in a heavy shipping carton and
will be banded to a skid. Immediately upon
receipt, inspect the carton carefully for exterior
damage.
CAUTION
SHIPPING STRAPS ARE UNDER TENSION
AND CAN SNAP BACK WHEN CUT. TAKE
CARE TO AVOID PERSONAL INJURY OR
DAMAGE TO THE UNIT BY STAPLES LEFT
IN THE WALLS OF THE CARTON.
Carefully cut any restraining straps around the
carton and detach the sides of the box from the
skid. Pull the carton up off the unit.
Thoroughly inspect for concealed damage.
Report any shipping damage or incorrect
shipments to the delivery agent. Write down the
model number, serial number, and installation
date, and retain this information for future
reference.
Space for these entries is provided at the top of
the Service Log at the back of this manual.
Keep the manual available for operators to use.
CAUTION
THIS UNIT IS VERY HEAVY. INSTALLER
SHOULD OBTAIN HELP AS NEEDED TO
LIFT THIS WEIGHT SAFELY.
When installation is to begin, carefully cut any
straps which hold the unit on the skid. Lift the unit
straight up off the skid. Examine packing
materials to be sure that loose parts are not
discarded with the materials.
The tangent draw-off valve is usually shipped
unassembled. Once the kettle is unpacked, it is
easily attached, as shown below. The large nut
which attaches the valve to the kettle should only
be hand tightened.
To Next Page
Loading...
Need help?
General
