11Grove RT600E
THIS CHART IS ONLY A GUIDE AND SHOULD NOT BE USED TO OPERATE THE CRANE.
The individual crane’s load chart, operating instructions and other instructional plates must be read and understood prior to operating the crane
Load chart RTE
Pounds
33 ft-105 ft
12,250 lb29 ft - 51 ft
100%
22 ft 6 in spread
360
°
Feet
**29 ft LENGTH 51 ft LENGTH
#0021 #0022 #0023 #0041 #0042 #0043
0
°
OFFSET
25
°
OFFSET
45
°
OFFSET
0
°
OFFSET
25
°
OFFSET
45
°
OFFSET
Pounds
33 ft-105 ft
12,250 lb
Stationary
360
°
Feet
#9005
Main boom length in feet
33 40 50 60 70
NOTES:
1. All capacities above the bold line are based on structural strength of
boom extension.
2. 29 ft and 51 ft boom extension lengths may be used for single line
lifting service.
3. Radii listed are for a fully extended boom with the boom extension
erected. For main boom lengths less than fully extended, the rated
loads are determined by boom angle. Use only the column which
corresponds to the boom extension length and offset for which the
machine is configured. For boom angles not shown, use the rating of
the next lower boom angle.
WARNING: Operation of this machine with heavier loads than the
capacities listed is strictly prohibited. Machine tipping with boom
extension occurs rapidly and without advance warning.
4. Boom angle is the angle above or below horizontal of the
longitudinal axis of the boom base section after lifting rated load.
5. Capacities listed are with outriggers fully extended and vertical jacks
set.
Courtesy of Crane.Market
To Next Page
Loading...
