Need help?Do you have a question about the Grow GM67 and is the answer not in the manual?
Overview of the GM67 1D 2D barcode scanner's features and capabilities.
Details technical specifications like scan mode, lighting, and read code types.
Provides physical dimensions and technical drawings of the barcode reader module.
Defines the pinout and connections for the scan head FPC interface.
Details UART and USB communication interface pin definitions and descriptions.
Illustrates the indicator, visual, and lighting areas for optimal scanning.
Lists supported barcode types and their default read/non-read status.
QR code to reset the module to its original factory default settings.
QR codes for enabling or disabling the setup code functionality.
Configuration and parameters for serial port communication.
Details USB Keyboard (KBW) connection mode.
Details USB COM Keyboard connection mode.
Describes two modes for manual reading: Button Holding and Button Trigger.
Explains continuous reading mode where the scanner reads automatically.
Enables automatic scanning based on detected changes in ambient light brightness.
Allows trigger and end of reading via host instructions.
Defines the duration for a single decoding attempt.
Sets a period where the scanner ignores repeated reads of the same barcode.
Controls the behavior of the LED illumination for reading.
Configures the pointing light beam for distance finding and its flashing behavior.
Settings related to keyboard output and layout.
Configuration for audible feedback from the scanner.
Controls the indicator light for successful decoding.
Sets the working mode for decoding prompts (Always off/on).
Handles 'unread' messages when decoding fails within a timeout.
Converts scanned data to uppercase, lowercase, or reverses case.
Specifies the format for outputting Chinese data (Original, GBK, Unicode).
Defines the character encoding format for input data.
Allows identification of barcode types using self-defined CODE IDs.
Adds specific characters after decoded data for termination.
Allows adding prefix and suffix strings to decoded data.
Options to hide parts of the barcode data.
Configures STX (Start of Text) and ETX (End of Text) characters.
Allows replacing specific characters within the barcode data.
Globally allows or forbids decoding of all barcode types.
Globally allows or forbids decoding of all 1D barcode types.
Globally allows or forbids decoding of all 2D barcode types.
Enables or disables reading barcodes from both directions.
Settings specific to UPC-A barcode decoding.
Settings for UPC-A additional codes (2-bit, 5-bit).
Settings specific to UPC-E barcode decoding.
Settings for UPC-E additional codes (2-bit, 5-bit).
Configures UPC-E to be read as UPC-A.
Configures UPC-A to be read as EAN-13.
Settings specific to UPC-E1 barcode decoding.
Settings specific to EAN-8 barcode decoding.
General| Resolution | 752x480 pixels |
|---|---|
| Light Source | LED |
| Processor | 32-bit RISC |
| Scan Rate | 300 scans per second |
| Interface | USB |
| Storage Temperature | -20°C to 60°C |
| Humidity | 5% to 95% (non-condensing) |
| Supported Symbologies | Code 39, Code 128, PDF417, QR Code, Data Matrix |
| Scanning Speed | 300 scans/second |
| Supported Barcode Types | 1D and 2D |
To Next Page
