Growatt 7000TL3-S - Wiring and Electrical Connections

31
32
6.3.3 Display interface
Overall display interface introduction
Three
Double
Double
Once
Double
Set Date/Time
Date：2012/04/05
Time：14:20:38
Once
Double
AC V Control:
Enable
Model:
PV0000F161
FW Version:
DH 1.0–DH 0.0
1 AC F Outrange
Time：14:20:30
FW Version:
Build：dhaa-0101
Date：2012/04/05
Time： 14:20:38
Once
Once
Once
Once
Once
Once
Double
Double
Double
Once
Once
Double Once
Once
Double
Once
Once
Once
Double
Once
Once
Once
Once
Once
Once
Once
AC VA/Watt:
VA W
Connect OK
AC V Control :
Disable/Enable
Set Com Address
003
Set Com Address
003
AC V Control :
Disable
Input Word:123
000
Input Word:123
123
Growatt
PV Inverter
SerNo:
PR34200090
Setting
Model:
PVBC00F161
FW Version:
DH 1.0–DH 0.0
Connect in: s
Etoday:
50 .2 Kwh
Power info
Input Info
Eall:
2000 Kwh
Etoday:
50 .2 Kwh
PV1 Volt: V
Power: W
PV2 Volt： V
Power: W
Output Info
GridFreq:50.0Hz
Set Info
Inverter info
SerNo:
PR34200090
COM Addr:
003
Power Rate: 20%
P_Factor: 1.0
AC VA/Watt:
VA W
1. Once: Next page
2. Double：Enter
3.Three: Enter the setting
4.Four: Back to cycle display interface
AC Error Record
1 AC F Outrange
Date：2016/04/06
1 AC F Outrange
AC F：48Hz
2 AC V Outrange
AC V：20.2V
2 AC V Outrange
Date：2016/04/06
2 AC V Outrange
Time：14:20:30
Eall:
2000 Kwh
AC Volt A/B/C
230V/230V/230V
Set Language Set Language
English
Once
Once
Once
Double
Fig6.3 Overall display interface
Power on display
After inverter restarts, the background light will last for 2 seconds. You can check the
inverter series number, model, firmware version. Refer Fig6.3.1.
Growatt
PV Inverter
SerNo:
PR34200090
Model:
PVBC00F161
FW Version:
DH 1.0–DH 0.0
Fig6.3.1Power on display
6.3.4 Operate by knock
Knock type and definition
Table 6.3.2 Knock definition list
Knock type
Definition
Single knock Down
Double knock Enter
Knock four times
Back to cycle display interface
The inverter can support four kinds of knock: single knock, double knock, third
Knock, Knock four times. Each kind of knock has different function. Refer to
specified definition in Table 6.3.2.
Three knock Make sure setting
Light backlight and single knock to check running information
Before light the backlight, the four types of knock functions are the same, which is
just lighting the backlight. Note that the background lighting will automatically turn
off if there is no knock detected in 10 seconds.
During cloudy days or in the area of low light, it’s inconvenient for users to check
inverter running information such as status, input data, output data, energy
generated. In this case user can light the backlight and check those data by single
knock, a single knock will switch LCD screen to a following interface.