Figure 7-2
Load type: confirm the connected load;
You need to configure the basic information of each connected load
separately: working power, custom name, settable load icon, and confirm
whether the temperature sensor is connected (after connecting the extra
temperature sensor, the load can be detected and controlled for temperature );
（2）Mode setting
Mode settings can be divided into two types, one is smart mode, the other
is PV linkage mode；
Note: Both temperature setting and temperature detection need to be set
and operated with a temperature sensor.
① Intelligent mode:
Power adjustment enable: only L1 can be set (can control load working
power);
There are two heating modes in the smart mode: constant temperature
and timing control modes, among which the L1 function is adjustable;
Constant temperature (temperature sensor needs to be installed): set
the constant temperature, the device will always keep at the certain
temperature;
Timing: To set the timing, you need to fill in the time, set the
temperature and times of repetition(up to 5 times). You can set different
temperature values according to different time periods, temperature
requirements and usage.
To Next Page
Loading...
Need help?
General