Growatt MID 10KTL3-XL - Page 18

29
30
Warning Code
Fault Discription
Suggestion
Warning 404
EEPROM abnormal.
1. Restart inverter.
2. If error message still exists,contact
manufacturer.
Warning 405
DSP and COM firmware
version unmatch
1. Check the firmware version.
2. If error message still exists,contact
manufacturer.
Warning 406
Boost module error
1. Restart inverter
2. If error message still exists, contact
manufacturer.
Warning 407
NTC Temperature too
high or NTC is broken
1. Restart inverter
2. If error message still exists, contact
manufacturer.
Warning 408
NTCBroken
1. Restart inverter
2. If error message still exists, contact
manufacturer.
Warning 409
CT Connect abnormal
1. Check the CT connect Whether it is
correct or not.
2. If error message still exists, contact
manufacturer.
13.2.2 Error code
Error Code
Fault Discription
Suggestion
Error 200
AFCI Fault
1. After shutdown,Check the panel terminal.
2. Restart inverter.
3. If error message still exists,contact
manufacturer.
Error 201
Leakage current too
high
1. Restart inverter.
2. If error message still exists,contact
manufacturer.
Error 202
The DC input voltage is
exceeding the maximum
tolerable value
1. Immediately disconnect the DC switch and
check the voltage
2. If the fault code still exists after the
normal voltage is restored, contact
manufacturer
Error 204
PV Reversed
1. After shutdown,Check the inverter
terminal.
2. Restart inverter.
3. If error message still exists,contact
manufacturer.
Error Code
Fault Discription
Suggestion
Error 300
AC V Outrange
1. Check grid voltage.
2. If the error message still exists despite the
grid voltage being within the tolerable
range, contactmanufacturer.
Error301
AC terminals reversed
1: Check AC terminals
2: If error message still exists, contact
manufacturer.
Error 302
No AC Connection
1. After shutdown,Check AC wiring.
2. If error message still exists,contact
manufacturer.
Error 303
PE abnormal
1. Check PE,to ensure that the PE line
contact good.
2. If error message still exisits,contact
Manufacturer
Error 304
AC F Outrange
1. Restart inverter.
2. If error message still exists,contact
manufacturer.
Error 305
Over Load Fault
1. Check whether output load over range; If
load too large, please reduce load.
2. If error message still exists, contact
manufacturer.
Error 306
CT LN Reversed
1: After shutdown，Check the SP-CT
connection.
2: If error message still exists,contact
manufacturer.
Error 307
Communication
fault,M3 didn't receive
SP-CT data
1: Check communication wire
2: If error message still exists,contact
manufacturer.
Error 308
Communication
fault;Pairing time too
long
1: Restart pairing
2: If error message still exists,contact
manufacturer.
Error 400
DCI bias abnormal
1. Restart inverter
2. If error message still exists, contact
manufacturer.
Error 401
DC Voltage High Fault
1. Restart inverter.
2. If error message still exists,contact
manufacturer.
Error 402
Output DC current too
high
1. Restart inverter.
2. If error message still exists,contact
manufacturer.