41
42
1.Restart the machine;
2.If the fault information still exists,contact the
manufacturer.
1.Restart the machine;
2.If the fault information still exists,contact the
manufacturer.
Abnormal
a u x i l i a r y p o w e r
supply
1.Restart the machine;
2.If the fault information still exists,contact the
manufacturer.
1.Restart the machine;
2.If the fault information still exists,contact the
manufacturer.
The grid voltage
sampling is
inconsistent
1.Restart the machine;
2.If the fault information still exists,contact the
manufacturer.
The firmware
version of the
control board and
the
c o m m u n i c a t i o n
board do not
match
1.Restart the machine;
2.If the fault information still exists,contact the
manufacturer.
Inconsistent
leakage current
sampling
1.Restart the machine;
2.If the fault information still exists,contact the
manufacturer.
Leakage c u r re nt
module is
abnormal
1. Restart the machine;
2.If the fault information still exists,contact the
manufacturer.
1.Restart the machine;
2.If the fault information still exists,contact the
manufacturer.
Redundant
sampling is
inconsistent
1.Restart the machine;
2.If the fault information still exists,contact the
manufacturer.
Abnormal battery
reverse
connection
protection tube
1.Restart the machine;
2.If the f a u l t information still exists,ontact t h e
manufacturer.
Battery voltage
sampling is
inconsistent
1.Restart the machine;
2.If the f a u l t information still exists,ontact t h e
manufacturer.
1.Restart the machine;
2.If the f a u l t information still exists,ontact t h e
manufacturer.
Manufacturer warranty 14
Please refer to the warranty card.
Decommissioning 15
15.1 Dismantling the Inverter
15.2 Packing the Inverter
1. Disconnect the inverter as described in section8.
2. Remove all connection cables from the inverter.
3. Screw off all projecting cable glands.
4. Lift the inverter off the bracket and unscrew the bracket screws.
CAUTION
Danger of burn injuries due to hot enclosure parts!
Wait 20 minutes before disassembling until the housing has cooled down.
If possible, always pack the inverter in its original carton and secure it with tension belts.
If it is no longer available, you can also use an equivalent carton. The box must be
capable of being closed completely and made to support both the weight and the size of
the inverter.
15.3 Storing the Inverter
Store the inverter in a dry place where ambient temperatures are always between -25°C
and +60°C.
15.4 Disposing of the Inverter
Do not dispose of faulty inverters or accessories together with household
waste. Please accordance with the disposal regulations for electronic waste
which apply at the installation site at that time. Ensure that the old unit and,
where applicable, any accessories are disposed of in a proper manner
To Next Page
Loading...
Need help?
General