Growatt ZigBee Module - FAQ; PAN ID Setting Failure; FF FE PAN ID Value; Wireless vs. Wired Monitoring

1. When set PAN ID, if the dialog box displays “Setting New PAN ID Failed”, the
setting fails. Please click on “Module Restart” → “Connect”, and then reset PAN ID
(refer to chapter4, step 3-7).
2. When read PAN ID, if the value box displays “FF FE”, the setting fails. Please click
on “Module Restart” → “Connect”, and then reset PAN ID (refer to chapter4, step 3-
7).As an alternative method, you could change the value of the PAN ID and channel,
then reset the data logger and ZigBee Module.
3. As to the same one inverter, either wireless method or wired method could be
chosen as a monitoring scheme. If not, the data logger couldn’t search inverters well.
6 FAQ
13