Need help?Do you have a question about the Grozone Control SCO2 and is the answer not in the manual?
General| Type | CO2 Controller |
|---|---|
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 70°C |
| Temperature Range | 0°C to 50°C |
| Humidity Range | 0-95% RH non-condensing |
| Display | LCD |
| CO2 Range | 0-2000 ppm |
| CO2 Accuracy | ±50 ppm |
| Temperature Measurement Range | 0°C to 50°C |
| Temperature Accuracy | ±0.5°C |
| Analog Output | 0-10V |
| Calibration | Automatic baseline calibration, manual calibration available |
| Sensor Compatibility | Internal CO2 sensor |
| Input Voltage | 100-240V AC, 50/60Hz |
| Relay Outputs | 2 SPDT relays (5A, 250V AC) |
Warning about sulphur vaporization damaging the controller and the need to cover it.
How to mount the controller and connect the power cord and CO2 generator.
How to set the high CO2 ppm value using the control knob.
How to set the low CO2 ppm value using the control knob.
Instructions for choosing between enrichment/exhausting and day/night modes.
How to select between Celsius (CELS) and Fahrenheit (FAHr) for temperature display.
How to set the high temperature limit for the shut-off function.
How the controller maintains CO2 levels and its high-temp shut-off.
How to toggle between displaying CO2 and temperature values on screen.
Guidance on verifying the CO2 sensor's accuracy and when calibration is needed.
Steps to enter calibration mode and begin the process.
Setting the reference value (e.g., 400 ppm) during calibration.
What to look for to confirm the calibration process was successful ("GOOD").
Essential requirements and conditions before starting troubleshooting tests.
A visual guide to diagnose and resolve issues with the SCO2 controller.
Understanding outcomes of troubleshooting steps to determine product status.
Explanations for error codes like Er.1 (Sensor) and Er.8 (Memory).
Procedure to reset the controller to its original factory settings.
Key instructions to follow before commencing the troubleshooting tests.
Performing the first steps of the test, including power-up and CO2 reading.
Adjusting CO2 high setpoint and testing operating modes F13/F14.
Verifying light sensor and CO2 level detection functionality.
How to check if the CO2 sensor requires calibration based on readings.
Guidance on what to do if the controller is damaged or malfunctions.
Contact details (phone, email, website) for technical assistance.
Details on the 3-year warranty, coverage, and product return procedures.
Instructions for retailers on handling defective product returns and RMA numbers.
Key technical specifications including output, input, sensor range, and features.
To Next Page
