Grundfos CR 1 - General Information; Removing the Transport Bracket

English (GB)
5
English (GB) Installation and operating instructions
Original installation and operating instructions.
CONTENTS
Page
1. General information
1.1 Removing the transport bracket
When removing the transport bracket, this procedure must be followed.
If the transport bracket is not removed correctly, the pump bearings and shaft
seal may be damaged.
1. General information
5
1.1 Removing the transport bracket
5
1.2 Fitting the motor
8
Read these instructions carefully before removing the
transport bracket.
Step Action Illustration
1
Remove the coupling guards,
if fitted.
TM02 8649 0704