EasyManuals Logo

Grundfos CR 90 Service Instructions

Grundfos CR 90
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12 / 20
4.7 Replacement of chamber stack
4.7.1 Dismantling
Remove the basic unit. See 4.6 Replacement of basic unit.
Slacken the nuts, (pos. 36), and remove them together with the washers, (pos. 66a).
Knock the pump head, (pos. 2a), free of the outer sleeve, (pos. 55), by means of a rubber mallet.
Remove the pump head and the outer sleeve.
Carefully pull the chamber stack, (pos. 80), up and free of the base complete, (pos. 6b).
Remove the O-rings, (pos. 37).
4.7.2 Assembly
Before assembly, clean all parts.
Apply O-ring grease to new O-rings, (pos. 37), and fit the rings in the base, (pos. 6b), and the pump head, (pos. 2a),
respectively. At the same time, replace the four rubber springs, (pos. 60), in the pump head.
Carefully fit the chamber stack into the base, (pos. 6b), and displace the straps 45° in relation to the staybolts.
Fit the outer sleeve, (pos. 55), into the base, (pos. 6b).
Fit the pump head, (pos. 2a), with the air vent screw, (pos. 18), in its previous position.
Fit the washers, (pos. 66a).
Lubricate the nuts, (pos. 36). Fit the nuts and tighten diagonally. See 2. Tightening torques and lubricants.
Continue the assembly. See 4.6 Replacement of basic unit.

Other manuals for Grundfos CR 90

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Grundfos CR 90 and is the answer not in the manual?

Grundfos CR 90 Specifications

General IconGeneral
BrandGrundfos
ModelCR 90
CategoryWater Pump
LanguageEnglish

Related product manuals