Grundfos CR 95 User Manual

English (GB)
15
5.1.2 Type key
5.2 Intended use of the product
Only use the CR, CRN pumps according to the
specifications stated in the installation and operating
instructions.
5.2.1 Applications
CR, CRN pumps are suitable for industrial
applications such as:
• water supply
• cooling
• heating
• pressure boosting
• water treatment
• liquid transfer of cold or hot clean liquids.
5.2.2 Pumped liquids
CR, CRN pumps are suitable for pumping liquids
which are thin, clean, non-flammable, non-
combustible or non-explosive liquids, not containing
solid particles or fibres.
When pumping liquids with a density and/or viscosity
higher than that of water, use motors with
correspondingly higher outputs, if required.
Whether a pump is suitable for a particular liquid
depends on a number of factors of which the most
important are chloride content, pH value,
temperature, content of chemicals and oils. Please
consult Grundfos for information about which pump
types are suitable for a specific liquid.
Example CR 95- 2 1- X- X- X- X- XXXX
Type range: CR, CRN
Rated flow rate in m
3
/h
Number of stages
Number of impellers with reduced diameter
Code for pump version
Code for pipe connection
Code for materials
Code for rubber pump parts
Code for shaft seal
DANGER
Fire and explosion
Death or serious personal injury
- Do not use the pump for flammable,
combustible or explosive liquids.
WARNING
Chemical attack and leakage
Death or serious personal injury
- Do not use the pump for liquids which
can attack the pump materials
chemically.
- Contact Grundfos if in doubt.
WARNING
Corrosive liquids
Death or serious personal injury
- Wear personal protective equipment.
WARNING
Toxic liquids
Death or serious personal injury
- Wear personal protective equipment.
CAUTION
Hot or cold liquid
Minor or moderate personal injury
- Wear personal protective equipment.

Grundfos CR 95 Specifications

General

Brand	Grundfos
Model	CR 95
Category	Water Pump
Language	English