5.1.1.2 Drain holes
The motor has a plugged drain hole on the drive side.
The drain hole is placed in the flange on the drive
side. You can turn the flange 90° to both sides or
180°.
With the drain hole open, the motor becomes self-
venting, allowing water and humid air to escape.
When you open the drain hole, the enclosure class of
the motor will be lower than standard.
TM029037
5.1.2 Changing the position of the operating panel
WARNING
Electric shock
Death or serious personal injury
‐ Switch off the power supply to the
product including the power supply for
the signal relays. Wait at least 5
minutes before you make any
connections in the terminal box.
You can turn the operating panel 180°. Follow the
instructions.
1. Loosen the four screws on the terminal box cover.
2. Remove the terminal box cover.
3. Press and hold in the two locking tabs (A) while
gently lifting the plastic cover (B).
TM084034
Lifting the plastic cover, shown on a Model J motor
4. Turn the plastic cover 180°.
Do not twist the cable more than 90°.
TM084035
Turning the plastic cover, shown on a Model J motor
5. Position the plastic cover correctly over the four
rubber pins (C). Make sure that the locking tabs
(A) are placed correctly.
TM084036
Positioning the plastic cover, shown on a Model J
motor
6. Fit the terminal box cover and cross-tighten the
four screws to 5 Nm.
Make sure that the terminal box cover
is aligned with the orientation of the
operating panel.
13
English (GB)
To Next Page
Loading...
