8
3.4 Installation example
The drawing in fig. 2 shows an installation example.
Fig. 2
3.5 Electrical connection
• The electrical connection of the pump should be
carried out by qualified persons in accordance
with local regulations.
• For electrical data of the pump, see section
2.2
.
• Do not lay signal cables, if any, together with
power cables.
TM01 8421 1600
The DME pump can be installed in many different ways. The sketch below shows an example with side-
fitted control panel. The tank is a GRUNDFOS chemical tank with a GRUNDFOS level control unit.
To Next Page
Loading...
