Fig. 31 Display – Running state
Fig. 32 Display – Fault state
6.3 Keypad operation
Operate the pump controller via operation panel. For the
detailed structure description of function codes,
see section 7.
6.3.1 Function code modification.
The PV pumping inverter has three levels of menus, which
are:
•
Group number of function code (first-level menu)
•
Tab of function code (second-level menu)
•
Set value of function code (third-level menu)
Press both the PRG/ESC and the DATA/ENT can return to the
second-level menu from the third-level menu. The difference is that
pressing PRG/ESC will save the parameter settings into the control
panel and then return to the second-level menu and shift to the
next function code automatically, while pressing PRG/ESC will
directly return to the second-level menu without saving the
parameter settings and keep staying at the current function code.
Under the third-level menu, if the parameter is not blinking, it
means the function code cannot be modify. The possible reasons
could be:
•
This function code is not modifiable parameter, such as actual
detected parameter, operation records and so on.
•
This function code is not modifiable in running state but
modifiable in stop state.
Example: Set function code P00.01 from 0 to 1.
Fig. 33 Parameter modification
Press and to modify the value.
6.3.2 Password Setting
GI SPC series pump controller provide password protection
function to users.
Set P7.00 for the password protection. Press PRG/ESC for the
function code editing state, "0.0.0.0.0" will be displayed. Set the
required password.
Set P7.00 to 0 to cancel password protection function.
Fig. 34 Password Setting.
Press and to modify the value.
6.3.3 Monitoring Pump controller state
GI SPC series pump controller provide group P17 as the
monitoring group. Users can enter into P17 directly to view the
value.
Fig. 35 Parameter Monitoring
Press and to modify the value.
To Next Page
Loading...
Need help?
General
