IMpress H/C
Overview.
The IMPRESS H/C model is an enhanced version of the IMPRESS ADVANCED
ADVANCED with some additional Hardware and Software. To connect either of
the transducers will result in a SYSTEM FAILURE and the controller will shut-down.
At-a-Glance
The noticeable differences are that the
TWIN version has a TWO COLOUR (red
& Blue) Control Panel Decal (eg Hot & Cold).
cables fitted, one for each plumbing circuit.
On Power-Up the display identifies with the
word DUAL.
Cable-Entry
Facilities for Cable Entry have been much expanded to keep abreast of the additional Alarm,
BMS/Telemetry and Communications features of the Impress Advanced Mk-2. The Bottom of
the Control Box is provided with two additional grey M16 Cable Glands and FOUR
additional knock-outs for M12 and M16 Cable Glands.
Control Panel (Base View) DUAL Version
M12 Cable-Gland
(Water-Low Sensor)
M12 Cable-Gland
(Pressure Transducer)
HOT
M12 Cable-Gland
(Pressure Transducer)
COLD
M16 Cable Gland
Power Entry
M16 Cable Gland
Pump-B Supply (HOT)
M16 Cable Gland
Pump-A Supply (COLD)
1 x M12 Knock-Out
4 x M16 Knock-Outs
Available for use as desired
Additionally the TWIN has TWO transducer
To Next Page
Loading...
