Related information
6.15.4 Setting the motor protection with Grundfos GO Remote
6.15.4 Setting the motor protection with Grundfos GO Remote
You can set the current, temperature and moisture protection via a setup wizard.
1. Go to Settings > Motor protection pump 1 or Motor protection pump 2.
2. Follow the on-screen wizard to set the following:
• Nominal pump current
• Trip IEC class
• Pump connection
• Overheat protection.
Related information
6.13 Setting the maximum number of restarts with Grundfos GO Remote
6.15.3 Moisture protection
6.16 Alarm reset
6.16.1 Resetting alarms and warnings manually with Grundfos GO Remote
1. Go to Alarms and warnings.
2. Press Reset alarm.
All current alarms and warnings have been reset. However, if the fault causing the alarm or warning has not been removed, the alarm or
warning will appear again.
3. If you want to delete all alarms and warnings from the history log, press Show log > Reset alarm and warning logs.
6.16.2 Setting the automatic alarm reset with Grundfos GO Remote
1. Go to Settings > Automatic alarm reset.
2. Select one of the following:
No automatic reset
The control unit does not reset any alarm or warning. You must do
it manually.
All except pump critical
The control unit resets alarms and warnings unless the related fault
can damage the pump.
All alarms
The control unit resets alarms and warnings, regardless of the
fault.
6.16.3 Resetting alarms and warnings on the operating panel
You can manually reset alarms and warnings on the operating panel. However, if the fault causing the alarm or warning has not been removed,
the alarm or warning will appear again.
1. Press Reset on the operating panel to reset the alarm or warning.
6.17 Setting the buzzer with Grundfos GO Remote
The internal buzzer is used to give an acoustic sound if there is a warning or an alarm.
1. Go to Settings > Buzzer settings.
2. Select when the buzzer is to be activated:
• All alarms
• All alarms and warnings.
6.18 Setting units for Grundfos GO Remote
Changing units as described here will only change the units shown in Grundfos GO Remote. It will not affect the units shown on the operating
panel of products connected to Grundfos GO Remote.
20
English (GB)
To Next Page
Loading...
Need help?
General
