Need help?Do you have a question about the Grundfos LS Series and is the answer not in the manual?
General| Brand | Grundfos |
|---|---|
| Model | LS Series |
| Category | Water Pump |
| Language | English |
Describes safety symbols and hazard levels like DANGER, WARNING, CAUTION.
Details on checking for damage during transport and handling.
General warnings and procedures for mechanical installation.
Instructions and warnings for safely lifting the pump unit.
Steps for pouring foundation and initial alignment.
Procedure for checking angular alignment using calipers or taper gauge.
Steps for checking coupling, soft foot, and parallel alignment.
Table detailing coupling clearance values and tolerances.
Method to identify and correct soft foot condition.
Procedure for checking parallel alignment using a straight edge.
Importance and types of inlet pipe installations.
Avoiding air pockets and turbulence in the inlet pipe.
Key checks to perform before starting the pump.
How to check and correct the motor's direction of rotation.
Priming procedure for flooded systems.
Priming procedure for suction lift systems.
Detailed steps for checking alignment using dial gauges.
Procedure for checking horizontal parallel alignment.
Routine checks to ensure proper pump operation.
General lubrication guidelines for the pump.
Table listing common faults and their potential causes.
Table listing solutions and remedies for identified faults.
Factors affecting pump operation and lifetime.
Further operating condition details.
To Next Page