Need help?Do you have a question about the Grundfos ALPHA1 L Series and is the answer not in the manual?
General| Pump Type | Circulator |
|---|---|
| Series | ALPHA1 L |
| Max Head | 6 m |
| Voltage | 230 V |
| Frequency | 50/60 Hz |
| Liquid Temperature Range | 2°C to 110°C |
| Max Operating Pressure | 10 bar |
| Insulation Class | F |
| Enclosure Class | IP42 |
| Application | Heating systems |
| Control Modes | Proportional pressure, constant pressure |
| EEI | 0.20 |
| Material | Cast iron |
| Power Input | Varies by model (e.g., ALPHA1 L 25-40 180: 3-22 W) |
| Pipe Connection | G 1 1/2 |
Check product against order and verify voltage/frequency.
Lists items in the box: pump, plug, gaskets, quick guide.
Guides mechanical mounting according to local regulations.
Specifies approved orientations for pump installation (horizontal motor shaft).
Details acceptable mounting positions for the control box.
Instructions for connecting the pump to the power supply.
Guidance on using insulating shells to reduce heat loss.
Ensures system is filled and vented before operation.
Steps to power on and initiate pump operation.
Procedure to remove air pockets for quieter operation.
Overview of ALPHA1 L as a standalone or integrated circulator.
Suitable uses in heating systems, including PWM control.
Lists acceptable liquids like water/glycol and notes on use.
Details on the nameplate and type key for pump identification.
Information on unions, valve kits, and insulating shells.
Lists available installer plugs, signal cables, and adapters.
Overview of the pump's control panel, buttons, and LEDs.
Introduces the different operational modes of the pump.
Details radiator and underfloor heating modes, and their pressure curves.
Explains constant speed settings, and recommendations for heating systems.
Details on PWM signal control, interface, and input/output profiles.
Illustrates pump performance curves based on settings.
How to set the pump using the operating panel and PWM signal.
Steps for safely removing the pump from the system.
Instructions for disassembling the electrical plug.
Procedure for clearing a blocked pump shaft.
Physical dimensions for specific ALPHA1 L models.
Physical dimensions for the ALPHA1 L 25-65 model.
How to read and interpret pump performance graphs.
Specifies conditions under which performance curves are valid.
Performance graphs for ALPHA1 L XX-40 (N) models.
Performance graphs for ALPHA1 L XX-60 (N) models.
Performance graphs for ALPHA1 L XX-65 (N) models.
To Next Page