Need help?Do you have a question about the Grundfos MAGNA3 25-40 (N) and is the answer not in the manual?
General| Model | MAGNA3 25-40 (N) |
|---|---|
| Material | Cast iron |
| Maximum Operating Pressure | 10 bar |
| Installation Length | 180 mm |
| Insulation Class | F |
| Frequency | 50 / 60 Hz |
| Head | 4 m |
| Approvals | CE |
| Supply Voltage | 230 V |
Details safety symbols found on the pump itself and their meanings.
Provides guidance on correct and safe methods for lifting the pump.
Covers the mechanical aspects of installing the pump, including pipe connections.
Guides on the correct orientation and positioning of the pump shaft.
Details the correct procedure for fitting the pump head to the housing.
Covers the electrical connection procedures and safety precautions.
Details the required supply voltage and frequency for the pump.
Step-by-step instructions for connecting the power supply cable.
Guides on starting up a single-head MAGNA3 pump.
Guides on starting up a twin-head MAGNA3 pump.
Specifies the types of liquids suitable for pumping with the MAGNA3.
Details the wiring diagrams for external connections.
Explains the pump's digital and analog input/output capabilities.
Explains the use of analog inputs for sensors and external signals.
Instructions on how to operate the pump and its control panel.
Access point for all pump settings and configurations.
How to set the desired setpoint for the pump's operation.
Options for setting the pump's basic operating mode (Normal, Stop, Min, Max).
Guide to selecting and enabling various control modes.
Adjusting gain (Kp) and integral time (Ti) for PI control.
How to enable and set the FLOWLIMIT function.
Table of recommended values for various control modes.
A step-by-step guide for setting up the pump's parameters.
Setting up the pump for multi-pump operation.
Guidance and corrective actions for pump failures.
Details the integrated sensor and its benefits.
Procedures for resetting and diagnosing faults.
To Next Page