Need help?Do you have a question about the Grundfos MAGNA3 25-60 (N) and is the answer not in the manual?
General| Model | MAGNA3 25-60 (N) |
|---|---|
| Category | Water Pump |
| Head Range | 0 - 6 m |
| Max. Head | 6 m |
| Max. Liquid Temperature | 110°C |
| Maximum Operating Pressure | 10 bar |
| Voltage | 1 x 230 V |
| Mains Frequency | 50/60 Hz |
| Insulation Class | F |
| Pipe Connection | G 1 1/2 |
| Connection Type | Threaded |
| Pump Housing | Stainless Steel |
| Material | Stainless Steel |
| Installation Length | 180 mm |
| Pump Type | Circulation Pump |
| Liquid Temperature Range | -10°C to +110°C |
| Enclosure Class | X4D |
| Protection Class | I |
| Approvals | CE, EAC |
Details safety symbols and their meanings relevant to pump operation.
Details procedures for physically mounting the pump, including flanged and threaded versions.
Explains how to correctly fit the pump head to the housing, ensuring sealing system integrity.
Provides steps for repositioning the control box and tightening the clamp securely.
Covers crucial electrical connection safety, regulations, and requirements.
Step-by-step guide for wiring the power supply to terminal-connected versions.
Details the initial startup procedure for single-head pumps, including control panel interaction.
Explains startup considerations for twin-head pumps and potential warning indications.
Illustrates wiring diagrams for terminal-connected and plug-connected versions.
Explains the function of digital inputs and relay outputs for pump control and indication.
Covers safe operation, especially regarding hot surfaces and control panel interaction.
Introduces the main settings menu for configuring pump parameters.
Guides on setting the desired head or flow rate for the pump's operation.
Details the various control modes available for pump operation and how to enable them.
Guides on adjusting controller constants (gain Kp, integral time Ti) for optimal performance.
Explains how to enable and set a maximum flow limit for the pump.
Provides a table of recommended setting values for various control modes and pump types.
Provides a guided setup process for configuring pump parameters.
Explains how to configure pumps for multipump operation (alternating, back-up, cascade).
Details multipump setup options like alternating, back-up, and cascade operations.
Offers guidance and corrective actions for pump failures.
Provides methods for resetting fault indications and general troubleshooting advice.
To Next Page