Grundfos MQ 3-45 - Page 21

Project2:Layout 1 4/22/11 6:59 PM Page 4
Untitled-1 1 4/22/11 7:07 PM
Project2:Layout 1 4/22/11 6:59 PM Page 4
Untitled-1 1 4/22/11 7:07 PM
Project2:Layout 1 4/22/11 6:59 PM Page 4
Untitled-1 1 4/22/11 7:07 PM
Project2:Layout 1 4/22/11 6:59 PM Page 4
Untitled-1 1 4/22/11 7:07 PM
Product Guide EZ Boost
TM
System
Main power supply to pump 1 x 200-240 V –10%/+6%, 60 Hz
1 x 110-115 V –10%/+6%, 60 Hz
Starting Soft starting.
Stopping SoftstoppingwhenstoppedbytheEZBoostcontroller
Run-uptime Maximum:2seconds.
Nolimitationtothenumberofstarts/stopsperhour.
Motorprotection Builtintothepump.
Protectionagainst:
Dryrunning
Overvoltageandundervoltage
230Vcutsoutat<150Vand>280V
115Vcutsoutat<75Vand>150V
Overload
Overtemperature
Soundpressurelevel
Thesoundpressurelevelis<74db[A]atadistanceof3feet(1meter).It is recommended by
Grundfos that the pump be installed with sound and vibration dampening equipment such as;
flexible piping adapters and anti-vibration mounting. The pump should not be mounted in or
adjacent to living quarters. The pump can also be wrapped with sound proofing insulation to
reduce noise. (See page 16, EZ Boost System Diagram.)
Resetfunction BMQEpumpscanberesetviaEZBoostcontroller.
Powerfactor PF=1.
Operationviagenerator ItisrecommendedthatthegeneratoroutputisequaltothemotorinputpowerP1[kW]plus
50%;min.P1+10%,however.
Pipeconnection 1.25”NPTinlet/1”NPTdischarge.
Strainer Holesofthestrainer:ø0.09”(2.3mm)
Marking ULListed,CE(SQEPumpwithMSE3motoronly)
Technical data - BMQE pump
20
Product Guide EZ Boost
TM
System
EZ Boost Controller
The EZ Boost controller is a control and communication
unitespeciallydevelopedfortheBMQEboosterpumpsin
constantpressureapplications.
TheEZBoostcontrollerprovides:
• FullcontroloftheBMQEpumps
• Two-waycommunicationwiththeBMQEpumps
• Possibilityofadjustingthepressure
• Alarmindication(LED)whenserviceisneeded
• The possibility of starting, stopping and resetting the
 pumpsimplybymeansofapush-button
TheEZBoostcontrollercommunicateswiththepumpvia
powerlinecommunication,meaningthatno extracables
arerequiredbetweentheEZBoostcontrollerandtheBMQE
pump.
TheEZBoostcontrollerfeaturesthefollowingindications
(seedrawingbelow):
1. Flowindicator
2. Systempressuresetting
3. SystemON/OFF
4. Buttonlockindicator
5. Dry-runningindicator
6. Serviceneededincaseof:
 –Nocontacttopump
 –Overvoltage
 –Undervoltage
 –Speedreduction
 –Overtemperature
 –Overload
 –Sensordefective
TheEZBoostcontrollerincorporatesexternalsignalinput
forpressuresensor and a pump statusrelayfor use with
devisesdependantonpumpstatus.
Voltage 1x100-240V–10%/+6%,60Hz
Power
consumption
5W
Current
consumption
Maximum130mA
Enclosureclass NEMA3R(IP55)
Ambient
temperature
Inoperation:-22to+122°F(-30to+50°C)
duringstorage:-22to+140°F(-30to+60°C)
Relative
airhumidity
95%
Pumpcable
MaximumlengthbetweenEZBoostcontrol-
lerandpump:650ft(198m).
Back-upfuse Maximum:16A
Marking ULListed,CE
Load Max.100mA
2 3
4
1
5
6
Powersupply
entry
Submersible
dropcableentry
Pressuresensor
entry
9 3/15 in. (232 mm)
4 1/2 in. (114 mm)
7 11/16 in. (195 mm)
21
L-DWS-PG-01 8-09.indd 21 11/12/11 12:49 AM