Need help?Do you have a question about the Grundfos PT and is the answer not in the manual?
General| Type | Pressure Tank |
|---|---|
| Maximum Working Pressure | 10 bar |
| Material | Steel |
| Membrane | Butyl |
| Liquid Temperature | 0°C to 100°C |
| Weight | Varies by model |
| Tank Volume | 8, 24, 50, 80, 100 liters |
Details the required run-in period for the shaft seal after initial startup or replacement.
Explains how to calculate required cut-in and cut-out pressures based on system variables.
Guides on adjusting the precharge pressure of the diaphragm tank to 90% of the cut-in pressure.
Provides instructions for adjusting the cut-out and cut-in pressures using the pressure switch screws.
To Next Page