Need help?Do you have a question about the Grundfos SE and is the answer not in the manual?
General| Model | SE |
|---|---|
| Protection class | IP68 |
| Category | Water Pump |
| Type | Submersible |
| Application | Wastewater, sewage, drainage |
| Impeller type | Vortex |
| Motor size | Varies by model |
| Outlet size | Varies by model |
| Maximum liquid temperature | 40°C (standard), 60°C (optional) |
| Max Flow Rate | Varies by model |
| Max Head | Varies by model |
| Power | Varies by model |
| Voltage | 230V or 400V |
| Frequency | 50/60 Hz |
| Material | Stainless steel, cast iron |
| Weight | Varies by model |
Explains hazard symbols and statements for safe operation.
Symbols for explosion-proof products and mandatory actions.
Identifies professional installers as the intended audience for these instructions.
Describes the SE and SL pumps designed for sewage and wastewater.
Specifies the applications for which the pumps are designed.
Lists the types of liquids the pumps are designed to handle.
How to identify the pump using the nameplate and type key.
Details explosion protection classifications (ATEX, ICEX) for Ex pumps.
Guidance on safe handling and transport of the pump, including weight.
Instructions for inspecting the pump after storage or transport.
Details on safe lifting procedures using lifting brackets or eye bolts.
Requirements for pump foundations, especially for pumps over 15 kW.
Details mounting procedures for different installation types (S, C, D, H).
Steps for permanent vertical installation using an auto-coupling unit.
Instructions for dry installations in permanent vertical or horizontal setups.
Steps for temporary vertical installation in a pit.
Guidelines for maintaining correct liquid level for pump operation and protection.
Specifies torque values for tightening bolts on inlet and outlet flanges.
Guidelines for operating the pump with a frequency converter, including safety.
Details on standard cable types, diameters, and bending radii.
Overview of sensors (thermal, moisture, vibration) and protection devices.
Instructions for checking and changing the motor liquid for cooling.
Guidance on checking and adjusting impeller clearance for performance.
Detailed steps for adjusting impeller clearance using set screws.
Specific maintenance requirements for explosion-proof SE and SL pumps.
Wiring diagram for single cable star-delta motor connections.
Wiring diagram for EMC-compliant single or double cables.
Schematics for connecting sensors in single cable pump configurations.
Schematics for connecting sensors in double cable pump configurations.
To Next Page
