Do you have a question about the Grundfos SQ and is the answer not in the manual?
Motor | Permanent magnet motor |
---|---|
Material | Stainless steel |
Protection class | IP68 |
Frequency | 50/60 Hz |
Application | Irrigation, Pressure boosting |
Pumped liquid | Water |
Power Supply | Single-phase or Three-phase |
Operating Temperature | 0 - 40 °C |
Statement of conformity with EU Machinery Directive (2006/42/EC) and relevant standards.
Statement of conformity with EU Low Voltage Directive (2006/95/EC) and relevant standards.
Statement of conformity with EU EMC Directive (2004/108/EC) and relevant standards.
Provides general information about the SQ/SQE pump and details to be filled on nameplates.
Details intended use and typical applications for SQ and SQE pumps, including special SQE-NE models.
Covers storage temperature limits, frost protection measures, and sound pressure level compliance.
Step-by-step instructions for refilling the motor with Grundfos motor liquid SML 2.
Details requirements for vertical and horizontal pump installation to ensure proper operation.
Explains the importance of liquid temperature for motor cooling and pump lifespan.
Guidelines for electrical connection by authorized personnel, safety precautions, and earth connection.
Notes that the motor incorporates built-in thermal overload protection, requiring no additional external protection.
Explains direct connection to mains and the role of a pressure switch for start/stop control.
General safety precautions to be observed before starting any installation work on the pump or motor.
Step-by-step guide for assembling the pump part and the motor correctly.
Procedure for removing the non-return valve if the pump is required without one.
Instructions for fitting the motor cable plug, intended for service personnel only.
Steps for correctly fitting the cable guard to the pump sleeve and cable plug.
Guidance on selecting the appropriate submersible drop cable cross-section and length based on motor power.
Recommendations for joining motor and submersible drop cables using a Grundfos cable termination kit.
Instructions for connecting pipes, including considerations for plastic and flanged pipes.
Guidelines for fitting cable clips at specified intervals for secure cable management.
Specifies maximum and minimum installation depths for vertical and horizontal pump setups.
Ensures well capacity and pump submersion before initiating pump start-up.
Specifies the minimum flow rate essential for motor cooling and ensuring pump longevity.
Guidance on selecting diaphragm tank size and setting precharge pressure and pressure switch parameters.
Details the motor's electronic protection against overload, dry running, voltage fluctuations, and overtemperature.
Notes that pumps are generally maintenance-free, but service kits and centres are available.
Procedure for servicing pumps used with hazardous or toxic liquids, including required documentation.
Steps to diagnose and resolve issues when the pump fails to start or operate.
Steps to diagnose and resolve issues when the pump runs but delivers no water.
Steps to diagnose and resolve issues when the pump operates at a reduced capacity.
Steps to diagnose and resolve issues causing frequent pump start/stop cycles.
Warns against using the megging procedure due to potential damage to the pump's built-in electronics.
Procedure for measuring supply voltage and identifying potential problems with the electricity supply.
Procedure for measuring current consumption to identify potential faults and load conditions.
Covers environmental regulations for handling hazardous materials during pump operation and maintenance.
Provides guidelines for the proper disposal of the product and its components according to local services.
Identifies the fields on the pump and motor nameplates that require user input for identification.
List of Grundfos contact details globally for sales inquiries and service support.
Identifies Grundfos registered trademarks and states the copyright ownership and rights.