Need help?Do you have a question about the Grundfos S Series and is the answer not in the manual?
General| Type | Submersible |
|---|---|
| Application | Wastewater, sewage, drainage |
| Impeller Type | Vortex |
| Motor Size | Varies by model |
| Motor Power | Varies by model |
| Discharge Size | Varies by model |
| Material | Cast iron, stainless steel |
| Liquid temperature | Up to 40°C |
| Max Flow Rate | Varies by model |
| Max Head | Varies by model |
| Voltage | Varies by model |
| Frequency | 50 Hz / 60 Hz |
| Max Particle Size | Varies by model |
| Temperature Range | Varies by model |
Explains hazard symbols and their meanings.
Explains important symbols used in the manual.
Identifies intended users of the manual.
Describes pump components and type identification.
Specifies applications and permissible liquids.
Details on the pump's nameplate information.
Details on Ex approval plates and certifications.
Information on cable entry certification.
Specifies conditions for using Ex pumps safely.
Procedures and safety for lifting the pump.
Identifies correct lifting points for balance.
Step-by-step guide to orient the pump vertically.
General guidelines for mechanical installation.
Describes horizontal, vertical, submerged, and dry installations.
Details for installing on auto-coupling systems.
Procedures for submerged and portable setups.
Steps for dry installations.
Steps for installing in column pipes.
Essential safety and connection guidelines.
Explains wiring diagrams for power and sensors.
Best practices and precautions for frequency converter use.
Details thermal and moisture protection mechanisms.
Information on level controllers and switches.
Describes the IO 113 interface and its capabilities.
Details the optional SM 113 module for data collection.
Lists included switches and sensors.
Explains thermal protection devices.
Details moisture detection and temperature sensors.
Information on WIO sensors and their installation.
Essential checks before initial startup.
Setting liquid levels for auto-coupling and dry installations.
Method to verify correct pump rotation.
Step-by-step guide for initial pump operation.
Procedures for storing the pump correctly.
Safety precautions for service and maintenance.
Routine checks and maintenance intervals.
Steps for checking and changing pump oil.
How to adjust impeller clearance for submersible types.
How to adjust impeller clearance for dry-installed types.
Procedures for pump cleaning and motor cable handling.
Details on cable entries and spare parts.
Guidelines for returning pumps for service.
Diagnosing and resolving pump start or stop problems.
Troubleshooting pump performance, noise, and leakage.
Specifies pH, temperature, density, flow, and liquid levels.
Covers electrical specifications, dimensions, and weights.
Instructions for proper product disposal.
To Next Page
