Grundig 43 GFB 5945 - Cable and Aerial Channel Tuning

47
ENGLISH
Searching for digital television
channels through cable
automatically
1 Open the »Input Source« menu with » «.
2 Select »DTV« using »
V « or » Λ « and
confirm with »OK«.
3 Press »MENU« to open the menu.
4 Press »
<
« or »
>
« to select the »CHANNEL«
menu and press »OK« to confirm.
– »CHANNEL« menu is now enabled.
5 Select »Auto Tuning« with »
V « or » Λ « and
confirm with »OK«.
– »Tuning Setup« menu will be displayed.
MENU ENTER
Tuning Setup
Back Start
Tune Type DTV
Country Turkey
Symbol Rate Auto
Frequency Auto
Network ID Auto
Scan type DVB-C
Scan Type Full
6 Go to »Scan Type« with » V « or » Λ « and
select »DVB-C« with »
<
« or »
>
«.
7 Go to »Country« with »
V « or » Λ « and
select the country with »
<
« or »
>
«.
8 Select »Tune Type« with »
V « or » Λ « and
select »DTV« with
<
« or »
>
«.
9 Select »Scan Type« using »
V « or » Λ « and
select (»Network Scan« or »Full«) with »
<
«
or »
>
«.
– »Network Scan« scanning function sets
the channels according to the cable
operator information in the broadcasting
signal.
– »Full« scan function scans the entire
frequency range selected. With this
search option, search can take a long
time. This search type is recommended.
Some cable providers do not support
»Quick« scan.
Note:
7
You can speed up the search. To do this,
frequency and network ID information are
required. You can obtain such information
from your cable provider or find them in
Internet forums.
10 Press »OK« to start the search.
– The »Channel Tuning« menu will be
displayed and the search for TV channels
will start.
– Search may take several minutes
depending on the number of television
channels received.
Note:
7
The search can be aborted with »EXIT«.
11 Press »EXIT« to end searching.
DETAILED CHANNEL SETTINGS
----------------------------------------------------