31 / 52EN
Refrigerator / User Guide
31
EN
PT
Using the product
6.13 Taking ice / water
(Optional)
To take water (
) / ice cube ( ) /
fragmented ice (
), use the display
to select the respective option. Take
water/ice by pushing the trigger on
the water fountain forward. When
switching between ice cube (
) / fragmented ice ( ) options, the
previous ice type may be discharged
a few more times.
• You must wait approximately 12
hours before taking ice from the
ice / water fountain for the first
time. The fountain may not disc-
harge ice if there is insufficient ice
in the ice box.
• The 30 pieces of ice cubes (3-4
Litres) taken after first operating
should not be used.
• In case of power blackout or tem-
porary malfunction, the ice may
partly melt and re-freeze. This will
cause the ice pieces to merge with
each other. In case of extended po-
wer blackouts or malfunction, the
ice may melt and leak out. If you
experience this problem, remove
the ice in the ice box and clean the
box.
A
WARNING: The product’s
water system should be
connected to cold water
line only. Do not connect to
hot water line.
• The product may not discharge
water during first operation. This
is caused by the air in the system.
The air in the system must be disc-
harged. To do this, push the water
fountain trigger for 1-2 minutes
until the fountain discharges wa-
ter. The initial water flow may be
irregular. The water will flow nor-
mally once the air in the system is
discharged.
• The water may be cloudy during
first use of the filter; do not consu-
me the first 10 glasses of water.
• You must wait approximately 12
hours to get cold water after first
installation.
• The product’s water system is de-
signed for clean water only. Do not
use any other beverages.
• It is recommended to disconnect
the water supply if the product will
not be used for long periods during
vacation etc.
• If the water fountain is not used for
a long time, the first 1-2 glasses of
water received may be warm.
To Next Page
Loading...
