Grundig GSBSPDM4FVX - Operational Safety

5 / 52EN
Refrigerator / User Guide
5
EN
PT
Safety instructions
floor covers under the product. Ths
may cause rsk of fre as a result of
nadequate ventlaton!
• Do not block or cover ventlaton holes.
Otherwse, power consumpton may
be ncreased and damage to your
product may occur.
• Do not connect the product to supply
systems such as solar power supples.
Otherwse, damage to your product
may occur as a result of the abrupt
voltage fluctuatons!
• The more refrgerant a refrgerator
contans, the bgger ts nstallaton
room shall be. In very small rooms,
a flammable gas-ar mxture may
occur n case of a gas leak n the
coolng system. At least 1 m of
volume s requred for each 8 grams
of refrgerant. The amount of the
refrgerant avalable n your product s
specfed n the Type Label.
• The nstallaton place of the product
shall not be exposed to drect sunlght
and t shall not be n the vcnty of a
heat source such as stoves, radators,
etc.
If you cannot prevent installation of the
product in the vicinity of a heat source,
you shall use a suitable insulation
plate and the minimum distance to
the heat source shall be as specified
below.
- At least 30 cm away from heat
sources such as stoves, heating units
and heaters, etc.,
- And at least 5 cm away from
electric ovens.
• Your product has the protecton
class of I. Plug the product n a
grounded socket that conforms wth
the Voltage, Current and Frequency
values specfed n the type label. The
socket outlet shall be equpped wth a
fuse wth a ratng of 10 A – 16 A. Our
company shall not be responsble for
the damages that shall be ncurred
as a result of operatng the product
wthout ensurng ground and
electrcal connectons made as per
local or natonal regulatons.
• The product’s power cable must
be unplugged durng nstallaton.
Otherwse, rsk of electrc shock and
njury may occur!
• Do not plug the product to loose,
broken, dirty, greasy sockets or
sockets that has come out their
seats or sockets with a risk of water
contact.
• Place the power cord and hoses
(if available) of the product so
that they shall not cause a risk of
tripping over.
• Penetration of humidity to live parts
or to the power cord may cause
short circuit. Thus, do not use the
product in humid environments or
in areas where water may splash
(e.g. garage, laundry room, etc.)
If the refrigerator is wet by water,
unplug it and contact an authorized
service.
• Do not connect your refrigerator
to power saving devices. These
systems are harmful for the
product.
1.6 Operational safety
•
Do not use chemical solvents on the
product. These materials contain an
explosion risk.
• In case of a failure of the product,
unplug it and do not operate until it
is repaired by the authorized service.
There is a risk of electric shock!