13 / 52EN
Refrigerator / User Guide
13
EN
PT
Installation
4.4 Electrical connection
A
WARNING: Do not
use extension or multi
sockets in power
connection.
B
WARNING: Damaged
power cable must be
replaced by Authorized
Service.
• Our firm will not assume responsibility
for any damages due to usage without
earthing and power connection in
compliance with national regulations.
• The power cable plug must be easily
accessible after installation.
C
Hot surface warning!
The side walls of your
product are equipped with
cooler pipes to enhance
the cooling system. High
pressure fluid may flow
through these surfaces,
and cause hot surfaces
on the side walls. This
is normal and it does
not require servicing. Be
careful when you contact
these areas.
4.5 Water connection
(Optional)
A
WARNING: Unplug the pro-
duct and the water pump (if
available) during connection.
The product’s water mains, filter and
carboy connections must be rendered
by authorizer service. The product
can be connected to a carboy or di-
rectly to the water mains, depending
on the model. To establish the con-
nection, the water hose must first be
connected to the product.
Check to see the following parts are
supplied with your product’s model:
3
1
4
2
*5
1. Connector (1 piece): Used to at-
tach the water hose to the rear of
the product.
2. Hose clip (3 pieces): Used to fix
the water hose on the wall.
3. Water hose (1 piece, 5 meter di-
ameter 1/4 inches): Used for the
water connection.
4. Faucet adapter (1 piece):
Comprises a porous filter, used
for connection to the cold water
mains.
To Next Page
Loading...
