FM mode
For the best FM reception, it is sufficient to extend
the telescopic antenna and direct it accordingly.
Selecting the input source FM
1 Select the input source FM with »Mode/
Alarm«.
– Display: »FM Mode«, then the frequency of
a FM radio station.
Selecting stored stations
1 Select the station you want using the preset
buttons »1« to »5« (presets 1 to 5) or using
»+5 eII« and the preset buttons »1« to »5«
(presets 6 to 10).
Displaying RDS station informations
RDS (Radio Data System) is an information sys-
tem which is transmitted additionally by most FM
stations.
Notes:
7
It may take some time before all RDS infor-
mation is available.
7
GRUNDIG has no influence on the correct-
ness of such information.
1 Press »Select/i« repeatedly.
– The following display appears in succesion:
The name of the radio station, radio text (if
offered), station type (PTY), the current time
and date.
Listening to an external source
1 Use a standard audio cable to connect »AUX
IN« on the back of the device to an AUDIO
OUT socket on the external equipment.
2 Press »ON/OFF« to switch on the device.
3 Select the input source for the external device
with »Mode/Alarm«.
– Display: »AUX IN Mode«.
4 Adjust the volume using »– +«.
5 Start playback on the external device.
Note:
7
If no audio signal is available on socket
»AUX IN«, the device switches automati-
cally to Stand-by mode after 15 minutes. For
further use switch on the device again.
To Next Page