Grundig TR 2500 DAB+ - Special Functions; Call Up the Software Version; Deleting All Settings (Reset); Removing DAB Radio Stations from the Program List

ENGLISH
28
SPECIAL FUNCTIONS
--------------------------------------------------------------------------------------------
Call up the software version
1 Open the menu with »Menu«.
2 Select the option »S
y
stem« with »r Tuning/
Skip e« and confirm by pressing »Select/i«.
3 Select the option »SW version« with »r
Tuning/Skip e« and confirm by pressing
»Select/i«.
– Display: actual software version.
4 Press »Menu« to end the display.
Deleting all settings (Reset)
This function enables you to reset all the custom
settings back to the default settings. All setings are
lost when you do this.
1 Open the menu with »Menu«.
2 Select the option »S
y
stem« with »r Tuning/
Skip e« and confirm by pressing »Select/i«.
3 Select the option »Factor
y
Reset« with
»r Tuning/Skip e« and confirm by pressing
»Select/i«.
– A safety confirmation is displayed.
4 Select the option »Yes« with »Tuning/Skip
e«.
Note:
7
To cancel the function select the option »No«
by pressing »r Tuning/Skip«.
5 Press »Select/i« to confirm setting.
– Display: »Restartin
g
«.
Removing DAB radio stations
from the program list
If you move to a different part of the country,
you should remove DAB radio stations, which
are no longer available from the program list.
These DAB radio stations are marked with “?“.
1 Open the menu with »Menu«.
2 Select the option »Prune« with »r Tuning/
Skip e« and confirm by pressing »Select/i«.
– A confirmation message is displayed.
3 Select the option »Yes« with »Tuning/Skip
e«.
Note:
7
To cancel the function select the option »No«
with »r Tuning/Skip«.
4 Press »Select/i« to confirm setting.
5 Press »Menu« to end the setting.
– In the program list you will find only avail-
able radio stations.
Software Update
You can install the latest version of the software,
if available.
1 Connect the device to a PC by means of the
socket located in the battery compartment.
2 Open the menu with »Menu«.
3 Select the option »S
y
stem« with »r Tuning/
Skip e« and confirm by pressing »Select/i«.
4 Select the option »Software Up
g
rade«
with »r Tuning/Skip e« and confirm by
pressing »Select/i«.
– A confirmation message is displayed.
5 Select the option »Yes« with »Tuning/Skip
e«.
– Display: »Waitin
g
«.
Note:
7
To cancel the function select the option »No«
by pressing »r Tuning/Skip«.
6 Start the update program on the PC.
7 Once the software is updated successfully, re-
move the device from the PC.