Grundig VISION 9 47-9870 T - Sound Setup and Calibration

ENGLISH
21
Connecting the microphone
1 Plug the microphone supplied into the microphone socket on the
television.
2 Set up the stand with the microphone in the listening position.
Starting automatic installation
1 Open the menu with »i«.
– The »PICTURE« menu is displayed.
2 Select the »SOUND« menu with » V « or » Λ « and press »G« to
confirm.
3 Select the »Sound Art Mode« with » V « or » Λ «.
4 Press »
–
« or »
+
« to select the »Surround« setting and press »G«
to confirm.
– The »EDIT SOUNDART« menu appears.
5 Select »Automatic Setup« with » V « or » Λ « and press »G« to
confirm.
– The »SOUNDART AUTO SETUP« menu appears.
6 Select »Start Auto Beam Setup« with » V « or » Λ « and press »G«
to confirm.
7 Press »G« to start the automatic setting.
– Avoid background noise during the automatic setting.
8 Once the setting for the automatic sound projection has been
made, press »
F
« (blue) to end the settings.
9 Select »Store User Setup« with » V « or » Λ « and confirm with
»
G«.
– The settings are saved.
SETTINGS
----------------------------------------------------------------------------------------------------
SOUND
Volume 5
Sound Type Stereo
Sound Art Mode Surround
Tone Control
Subwoofer On
Headphone
Back Enter Close
1
EDIT SOUNDART
Sound Art Mode
r
Surround
e
Channel Volume
Automatic Setup
Manual Setup
Recall Preset User
Back Close
1
SOUNDART AUTO SETUP
Start Auto Beam Setup
e
Beam Test Off
Store User Setup
Back Start Close
1