To Next Page
M
morrislindaSep 6, 2025
What does 'Re- ~ Boot!' mean on GSE Accessories?
- KkarencolemanSep 6, 2025
The message 'Re- ~ Boot!' on GSE Accessories means that EEPROM data could not be read and the unit is attempting a power-up reset.
What does 'Re- ~ Boot!' mean on GSE Accessories?
The message 'Re- ~ Boot!' on GSE Accessories means that EEPROM data could not be read and the unit is attempting a power-up reset.
What does 'Bad ~ Code!' mean on GSE Accessories?
The message 'Bad ~ Code!' on GSE Accessories indicates that an incorrect access code was entered.
What does 'Add ~ Load!' mean on GSE Accessories?
If 'Add ~ Load!' is displayed after performing a count sample on your GSE Accessories, this message indicates that a larger sample size is required.
What does 'T.X.YYYY' mean on GSE Accessories?
The message 'T.X.YYYY' on GSE Accessories means that catastrophic errors occurred in the software, a trap error may occur and freeze the display with address information. Press any key five seconds after viewing message to reboot the unit.
What does 'Need APS' mean on GSE Accessories?
The message 'Need APS' on GSE Accessories indicates that a setpoint start is initiated and the setpoint is based on quantity, but no piece weight has been established, so the start will not occur.
What does 'A-D ~ Bad!' mean on GSE Accessories?
The message 'A-D ~ Bad!' on GSE Accessories indicates a problem with the A/D chip. Disconnect any Or Code17 options installed and re-power the unit.
What should I do if my GSE 350 displays 'Problem with A/D chip detected'?
If your GSE Touch Panel displays 'Problem with A/D chip detected', disconnect any options installed and re-power the unit.
What does 'Unit ~ Seald' mean on GSE Accessories, and how to fix it?
The message 'Unit ~ Seald' on GSE Accessories means access to the Setup or Calibration Mode was denied. You should check the internal “YES/NO” program jumper.
What to do if my GSE Touch Panel displays 'Trans~Hold2'?
This message on the GSE Touch Panel indicates that data transmission is being blocked because of a deasserted handshake on communication port 2. To resolve this, press the [ZERO] or [CLR] button to stop the transmission and then check P204.
What to do if my GSE 350 displays 'Under Load'?
If your GSE Touch Panel displays 'Under Load', check the load cell wiring.
General| Display Type | TFT LCD |
|---|---|
| Touch Panel | Yes |
| Touch Technology | Resistive |
| Power Supply | 24 VDC |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Interface | Ethernet |
| Humidity | 10% to 90% non-condensing |
| Protection Level | IP65 |
| Operating Voltage | 24V DC ±10% |
