What does 'Need APS' mean on my GSE 355?
The 'Need APS' message on your GSE Touch Panel means a setpoint start was initiated, but the setpoint relies on quantity and no piece weight has been established. The start will not occur until a piece weight is established.
What to do if my GSE 355 Touch Panel displays 'Under Load'?
If your GSE Touch Panel displays 'Under Load', check the load cell wiring.
What does it mean when my GSE Touch Panel displays 'Input signal greatly exceeds the valid range'?
This message indicates that the input signal is far beyond what is expected. To resolve this, check the load cell connection of your GSE Touch Panel.
What does 'Receive buffers capacity was exceeded' mean on my GSE 355 Touch Panel?
The message 'Receive buffers capacity was exceeded' on your GSE Touch Panel indicates a handshaking problem.
What to do if data transmission is inhibited on communication port 1 of my GSE 355?
If data transmission is inhibited due to a deasserted handshake on communication port 1 of your GSE Touch Panel, press or to abort transmission.
What does 'Out of ~ Range' mean on my GSE 355?
The 'Out of ~ Range' message on your GSE Touch Panel means you tried to enter a value that is beyond the allowable range.
What does 'Add ~ Load!' mean on my GSE 355 after a count sample?
If your GSE Touch Panel displays 'Add ~ Load!' after performing a count sample, it means that a larger sample size is needed.
What does 'Add ~ Load!' mean on my GSE Touch Panel during calibration?
The 'Add ~ Load!' message on your GSE Touch Panel means that the calibration weight is less than 0.1% of the capacity. You need to add more weight.
What to do if my GSE Touch Panel displays 'Trans~Hold2'?
This message on the GSE Touch Panel indicates that data transmission is being blocked because of a deasserted handshake on communication port 2. To resolve this, press the [ZERO] or [CLR] button to stop the transmission and then check P204.
What should I do if my GSE 355 displays 'Problem with A/D chip detected'?
If your GSE Touch Panel displays 'Problem with A/D chip detected', disconnect any options installed and re-power the unit.
General| Brand | GSE |
|---|---|
| Model | 355 |
| Category | Touch Panel |
| Language | English |
To Next Page
