What to do if GST I-9105R report a fault after the control panel powers on?
If your GST Security Sensor reports a fault after the control panel powers on and registers, it might not be in a normal working state. Try commissioning it again to resolve the issue.
What to do if GST I-9105R Security Sensors give a fault signal after a period of normal operation?
If your GST Security Sensor gives a fault signal after a period of normal operation, it means that the detector can’t work normally. Commission it once more.
Why does the Fault LED constantly illuminate on GST I-9105R Security Sensors after power up?
If the Fault LED constantly illuminates after powering up your GST Security Sensor, it could be due to a wrong device type. Program the device type 51 or 52 again.
How to fix GST Security Sensors if working LEDs are not lit after power up?
If the working LEDs on your GST Security Sensors are not lit after powering up, the possible causes and solutions are: * If the 24V power is off, or the working LEDs, transient suppressor VD12, diodes VD1, VD2, VD10, VD11, or components N1, N2 are damaged, replace the component with problem. * If the flexible cable inside was not connected, or not connected correctly, connect again in right way.
What to do if GST I-9105R Security Sensors alarm and give a fault signal after restart?
If your GST Security Sensor alarms after operating for some time and gives a fault signal after restart, the detector has deviated due to external vibration. Commission it once more.
Why is the Green LED constantly flashing on GST Security Sensors after power on?
If the Green LED is constantly flashing on your GST Security Sensor after powering on, it could be due to: * A damaged emitting diode or circuit. * A damaged receiving diode or amplifying circuit. Replace the component with problem.
Details the step-by-step procedure for initial detector setup and alignment.
Describes the procedure for testing the fire alarm functionality of the detector.
Explains how to test the fault reporting capability of the detector.
Guides the user on how to program the unique address for the detector.
General| Detection Angle | 90° |
|---|---|
| Operating Voltage | 24VDC |
| Operating Environment | -10°C to +55°C |
| Relative Humidity | ≤ 95% (non-condensing) |
| Dimension | 110mm x 65mm x 42mm |
| Dimensions | 110mm x 65mm x 42mm |
To Next Page
