76
PART 2
Operating an E-Bike (1 of 4)
138692 Rev 0 (04/22)
Section A. Important Safety Information
GT Bicycle Owner’s Manual
Operating an E-Bike (1 of 4)
WARNINGS
Operating the Drive Assist System
Turning the drive assist system ON before you are seated and have both hands on the handlebar could
result in loss of control of the E-bike. Always have total control of the E-bike and be ready to ride before
engaging the drive system.
The E-bike’s drive assist system will increase or decrease the acceleration of the bike. It is the rider’s
responsibility to appropriately judge the riding conditions (e.g. road conditions, tight turns) and current
speed of the E-bike before adjusting the drive assist system.
Anticipating changes in speed and providing time to react appropriately is critical to using the drive assist
system. Always check your surroundings and conditions before accelerating and set the assistance level
to lowest assist, or off, when descending hills.
The drive assist system will not function properly without the display (E-bike computer) properly attached
to the base. If the display (E-bike computer) becomes disconnected from the base during a ride, the
speed of the E-bike will change. Unexpected deceleration may impact your riding conditions and other
vehicles near you. Always be prepared to pull off to a safe area in case the display (E-bike computer)
becomes disconnected from the base.
Importance of practice & rider training
Before you ride this bike, practice riding in a safe area free from hazards. Take time to learn to bike’s
controls and performance. Practice the controls and gain the experience necessary to avoid the many
hazards you will encounter while riding.
To Next Page
Loading...
