78
PART 2
Operating and E-Bike (3 of 4)
138692 Rev 0 (04/22)
Section A. Important Safety Information
GT Bicycle Owner’s Manual
Operating and E-Bike (3 of 4)
WARNINGS
Changing the assistance level while riding: Changing the drive-assistance level while riding will
increase or decrease the acceleration of the bike. You should anticipate this change in speed and react
appropriately depending on the riding conditions such as on slippery trails, tight turns, or unstable or
uneven surfaces. Set assistance level to “eco” (lowest assist) or to “off” before descending technical
trails, (e.g., tight downhill switchbacks).
When not riding: Turn the drive system off to prevent unauthorized use.
Do not ride the e-bike without the battery. Make sure the battery is fully charged before every ride to
help ensure adequate battery power for necessary lighting and for the drive system.
Do not remove any lighting or reflectors and do not ride if they do not work.
Do not allow children to operate or to come into contact with the e-bike or its parts.
Only turn the drive system on when you are seated ready to ride.
Accidental activation: Always disconnect the battery from the bike before working on the bicycle. If
you transport the bike by car or by airplane, obey local regulations regarding transporting a bicycle
with a drive system battery. Accidental activation of the bicycle drive system can result in serious
injury.
To Next Page
Loading...
