Table of contents.
1 Check out list Page 1
2 Start-up Page 1
3 Turning on and off the FF310T and FF310R Page 1
4 Setting the sensitivity level Page 2
5 How to use the sensor Page 3
6 Locating short circuits Page 3
7 Wire tracing Page 4
8 Locating current leaks Page 4
9 Locating open circuits Page 5
10 Wire identifi cation Page 5
11 Hook up reference chart Page 6
12 General procedures Page 7
13 Special tracing procedures Page 8
14 Technical specifi cations Page 10
15 CT8002AA Professional Circuit Tester Page 10
16 CT6100 Fuse Socket Connectors Page 11
17 Care of the unit Page 11
18 Warranty Page 12
Caution
Very Important: Read this fi rst
•
For use only with DC voltage. Do not connect to circuits exceeding 42 volts DC under
any circumstances.
•
DO NOT USE on AC voltage.
•
Do not use on any circuit directly or indirectly connected to AC lines or any other AC
power source.
•
Do not use with any component or part of the ignition system.
•
Before using this device check the vehicle’s electrical wiring and disconnect any part
or subsystem sensitive to voltage and current pulses such as air bags, electronic
control modules, etc.
•
Always follow the instructions and procedures indicated in the vehicle’s
service manual before attempting to disconnect any part or subsystem of the
electrical circuit.
Exceeding the limits listed above when using this apparatus, or not observing
the precautions listed above can expose you to physical injury and permanently
damage your instrument and parts and components of the vehicle under test.
“V Ready” and “GTC” are registered trademarks of General Technologies Corp.
To Next Page
Loading...
Need help?
General
