Fig.2 - Set up for tracing short
or open circuits, or
location of wiring
Fig.3 - Set up for tracing
short and open
circuits, or tracing
wiring
Fig.4 - Set up for tracing
open circuits or iden-
tifi cation of wires
Fig.5 - Set up for upstream
tracing of open
circuits or location of
wires
11- Hook up reference chart
Page 6
• For identifying wires without load connected: Connect the FF310T as
described in section ‘9- Locating Open Circuits’ to the circuit to be identifi ed, then
proceed to scan all suspected wiring with the FF310R’s sensor, until the fl ashing and
beeping is at its maximum. In the case of tightly packed wires ( bundles, conduits, etc.),
it may be necessary to spread these apart to facilitate the identifi cation process of
a particular wire.
To Next Page
Loading...
