Gtech AirRAM MK2 K9 - Replacing the filters; Removing and cleaning the brush bar

Slide the filter onto the inner shroud. Slide the filter and inner shroud into the filter
housing.
If the brush bar jams during use, the AirRAM
K9 will stop and the LEDs will appear red.
Before checking for a blockage, remove the
battery.
Rest the AirRAM K9 on its side and locate
the brush bar button on the right hand side.
Press the button inwards and then pull
the brush bar out from the bottom of
the AirRAM.
12
Replacing the filters
Removing and cleaning the brush bar
4107_AR30_UK_manual_aw.indd 124107_AR30_UK_manual_aw.indd 12 10/02/2020 11:2110/02/2020 11:21