The brush bar can now be removed, starting at
the button end.
To remove hair from the brush bar, run an
open pair of scissors down the groove to cut
the hair, then pull it out.
Re-insert the brush bar, starting by the end
furthest away from the button. Then line up
and push the brush bar into the AirRAM K9
until it clicks into place.
Replace the battery by sliding it down into the
head assembly. It will click into place.
13
4107_AR30_UK_manual_aw.indd 134107_AR30_UK_manual_aw.indd 13 10/02/2020 11:2110/02/2020 11:21
To Next Page
Loading...
