13
If the brush bar jams during use, the AirRAM
will stop and the LEDs will appear red. You will
need to remove and clean the brush bar (see
page 11).
The AirRAM will not re-start until the red lights
go out. This will take ten seconds.
If the problem persists, follow the
troubleshooting instructions below.
AIRRAM TECHNICAL SPECIFICATION
Battery model 103A022
Battery 22V 2000mAh Li-Ion
Charging period 4 hours
Battery charger output 27V DC 500mA
Weight 3.2kg
The symbol indicates that this product is
covered by legislation for waste electrical and
electronic products (EN2002/96/EC)
When the vacuum has reached the end of its life, it and
the Li-Ion battery it contains should not be disposed of
with general household waste. The
battery should be removed from the vacuum and both
should be disposed of properly at a
recognised recycling facility.
Call your local council, via amenity site, or
recycling centre for information on the disposal
and recycling of electrical products.
Alternatively visit www.recycle-more.co.uk
for advice on recycling and to find your nearest
recycling facilities.
FOR HOUSEHOLD USE ONLY
10
seconds
Clearing a jam / fault
4092_AR29_UK_manual_aw.indd 134092_AR29_UK_manual_aw.indd 13 10/02/2020 14:3010/02/2020 14:30
To Next Page
Loading...
